Thermal spray applications for engineering coatings in the automotive and transport industry
Engineering coatings are commonly defined as a coating that alters the surface properties of the item being sprayed. This could be a coating to decrease the wear rate of an item or to act as a thermal barrier coating.
Engineering coatings are also commonly used to restore the physical dimensions on worn items to reclaim/repair them.
In a typical engine, thermal spray or laser clad coatings can be used to repair crankshafts; produce hard wearing valve seats; prevent cylinder bore wear; coat piston rings to make them harder wearing; re-surface cylinder heads, repair camshaft bearings and re-surface clutch pressure plates.
Another long-standing application is the coating of wear areas on gearbox synchro-ring selector forks.
In the railway industry, train points are metal spray coated as well as re-claiming worn axle bearings and wheel mounts.
An increasingly common application is the spraying of ceramic thermal barrier coatings onto exhaust manifolds. The thermal barrier coating helps to keep exhaust temperature within the exhaust system and hence reduce the temperature within the engine bay which can give significant performance enhancement, particularly in performance and motorsport applications.
Below is a small selection of the very large number of potential automotive and transport industry engineering coating applications. If you don’t see your exact application but are inspired to see the possibilities that may assist you, please feel free to reach out to us by phone or email.
Reason for use: Thermal barrier coating of exhaust components Download PDF Metallisation customer, Woof Thermal Management Technology, has applied well proven plasma ceramic coatings technology to high performance automotive applications, to provide highly effective thermal barriers in extreme conditions. Related Products Met-PCC(PLAS) View Product Metallisation Ceramic Coatings Woof Thermal Management Technology, based in Bradford, West Yorkshire, provides premium specialist coatings and engineering services to industry and end users. The plasma ceramic coatings range has been developed for the nuclear industry,…Read More
Application Data Sheets
Reason for use: During use, the clutch diaphragm spring will wear on its tip ends at the point where it comes into constant contact with the thrust bearing. Download PDF Related Products MK61-FS Wire Flame View Product The clutch diaphragm spring in itself is not particularly an expensive item, however, the labour involved in removing the old spring from its housing then replacing it with new will push up the total cost of clutch refurbishment. By using the Metallisation flamespray…Read More
Reason for use: To produce a low friction coating, dimensionally stable throughout it’s working life. Download PDF Related Products MK61-FS Wire Flame View Product Met-PCC(PLAS) View Product Further Reading Introduction to Thermal Spray and Engineering Applications Thermal Spraying Stands the Test of Time – The Forth Road Bridge A piston is defined as a ‘cylindrical piece moving to and fro in a hollow cylinder as in engines or pumps’. To seal the gases during the compression and work strokes of…Read More
Reason for use: Repair worn steel cast release levers Download PDF Related Products MK74 Powder Flame View Product The powder flame spray reclamation of clutch release levers and many other automotive components has now become common practice. By using the flame spraying process, considerable savings may be made over replacement costs. Savings of up to 50% are common where on large components, savings of up to 90% may be achieved. It is sometimes advisable to use fused coatings on components…Read More